crwdns2933803:03crwdne2933803:0
crwdns2933797:0Zephoskcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Zephosk
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] On the bottom of the camera, remove the following screws: |
|---|---|
| + | [* red] Four M1.7x5.0mm Phillips #000 screws |
| + | [* black] Using a plastic opening pick, partially peel up the top of the back rubber grip. |
| + | [* black] Carefully begin lifting the back cover up away from the camera body. |
| + | [* icon_caution] Do not lift it all the way off. There is still a ribbon cable attaching the back cover to the main PCB board. |
| + | [* orange] Using a plastic spudger tool, gently pry off the back cover ribbon cable from the main PCB board. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0