crwdns2933803:08crwdne2933803:0
crwdns2933797:0Markcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Mark
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] At this point, all of the screws holding the two halves of the case should be removed. Time to ***pry the bottom and top half of the case from each other*** |
|---|---|
| + | [* icon_note] Don't be surprised if this takes a while. Also don't worry about being too gentle with the clips on the case - if they break, they will still be held in place by the screws we've just taken out |
| + | [* icon_note] The first shot shows the ***area around the hinges - I recommend starting here***. Just beside the left side of the battery I found it especially stuck... you'll probably need some heavy use of your spudger, just be cautious when using a ***screwdriver*** as it can ***bend the plastic permanently*** |
| + | [* black] Once the back is separated, just use your hands to pry from the sides. Move towards the bottom. Once at the bottom, ***pull north*** and it should separate the top case from the bottom half |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0