crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:03crwdne2933803:0

crwdns2933797:0Dmitrycrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Dmitry

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* black] Если вы вставите тестовую плату так, как на фото, тогда: D- и D+ это контакты USB2.0 части разъёма А2,А3 + А10,А11 + В2,В3 + В10,В11 это TX и RX пары USB3.0 части
-[* black] The TX and RX pairs of USB 3.0 should be the same in both directions and be 550..650 during diode ringing in both directions
+[* black] If you insert the test board as shown in the photo, then: D- and D+ are the pins of the USB2.0 part of the connector A2,A3 + A10,A11 + B2,B3 + B10,B11 are the TX and RX pairs of the USB3.0 part
+[* black] The TX and RX pairs of USB 3.0 should be the same in both directions and A10-A11 & B10-B11 must be 600+\- during diode ringing in both directions