crwdns2933803:011crwdne2933803:0
crwdns2933797:0Ben Moorescrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Ben Moores
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Remove Landscape-Portrait Ring | |
| [* black] Using a PH0 Screwdriver remove the three silver screws in the middle ring of screws. | |
| [* icon_caution] Do not remove any of the 3 black screws in the recessed holes or the 3 silver screws nearest the back lens. | |
| [* black] Lift the orientation ring. There are some felt pads on the lower lip that make it a little stiff, but it will lift out. | |
| [* icon_caution] Note that one of the FPC is connected to the orientation ring. | |
| [* icon_caution] Note that one of the plastic tabs has an orientation pillar that fits into the small hole near one of the screws. | |
| [* icon_caution] Be very careful if you disassemble the orientation ring. There is a sping loaded detent roller that is difficult to re-fit. | |
| - | [* black] Screws: 3@ M1. |
| + | [* black] Screws: 3@ M1.6 x 4mm (white threadlock) |
| [* black] FPC Marking: XL1406_FPC_ENCODER_FPC_Rev03 UFK144513 |