crwdns2933803:05crwdne2933803:0
crwdns2933797:0James Huangcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 James Huang
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Unscrewing Main Nut | |
| [* black] At the bottom of the microphone is a large nut that holds the body together. There are two recessed spots that can be used to loosen/tighten the nut. | |
| [* black] A simple wrench can be made from a scrap piece of wood and two small nails. Drill two holes 32mm apart in the wood with a bit smaller than the nails. Tap the nails in, and if possible, cut and sand the tips so that they are flat and of the same height (prevents slipping). | |
| [* black] If the nails do not fit in the recesses, they can be bent until they do. | |
| - | [* black] If the nails flex too much and slip out while tightening, shortening the nails |
| + | [* black] If the nails flex too much and slip out while tightening, shortening the nails will make them stiffer. |
| [* black] Once the nut is loosened, it is quicker to unscrew it the rest of the way by hand. |