crwdns2933803:05crwdne2933803:0
crwdns2933797:0James Huangcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 James Huang
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Unscrewing Main Nut |
|---|---|
| + | [* black] At the bottom of the microphone is a large nut that holds everything together. There are two recessed spots that can be used to loosen/tighten the nut. |
| + | [* black] A simple wrench can be made from a scrap piece of wood and two small nails. Drill two holes 32mm apart in the wood with a bit smaller than the nails. Tap the nails in, and if possible, cut and sand the tips so that they are flat (prevents slipping). |
| + | [* black] If the nails do not fit in the recesses, they can be bent until they do. |
| + | [* black] If the nails flex too much and slip out while tightening, shortening the nails can make them stiffer. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0