crwdns2933423:0crwdne2933423:0

crwdns2933803:05crwdne2933803:0

crwdns2933797:0Damiancrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Damian

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[title] Unscrew and remove trigger mount
[* black] Turn the printed circuit board over, and remove two Torx T6 screws in the top corners holding the trigger mounts in place.
-[* black] Once the screws are removed, the printed circuit boards, trigger mounts, and the top bar assembly holding the micro USB charging pre-drilled hole and outside bumper buttons.
+[* black] Once the screws are removed, we should have:
+ [* black] the printed circuit board,
+ [* black] trigger mounts,
+ [* black] and the top bar assembly holding the micro USB charging pre-drilled hole and outside bumper buttons. These are technically two pieces, but they sandwich together easily at four square points in the middle.