crwdns2933803:05crwdne2933803:0
crwdns2933797:0Uchenna Oniahcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Uchenna Oniah
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Install the new battery | |
| [* black] Apply flux to the tinned pad | |
| - | [* black] Holding the body of the battery position the tinned wire |
| + | [* black] Holding the body of the battery position the tinned wire onto the on the tinned pad. (Photo 1) |
| [* icon_caution] If you're replacing the battery on the left earbud then the pad corresponding to black wire will be labeled ''***BAT -***'' on the PCB. (Photo 2) | |
| [* icon_caution] If you're replacing the battery on the right earbud then the pad corresponding to red wire will be labeled ''***BAT +***'' on the PCB. (Photo 3) | |
| [* black] While holding the wire in place with one hand use the other hand to place the tip of the iron onto the pretinned wire until the solder melts and the the wire is drawn into the blob of solder on the pad. (Photo 1) | |
| [* icon_note] Nudge the solder joint with a pair of tweezers to ensure that the wire is securely attached to the pad | |
| [* black] Repeat the above steps for the second battery terminal wire | |
| - | |
| + | [* icon_caution] Make sure that there is no solder that is bridging the two pads together that would short circuit the battery. |