crwdns2933803:013crwdne2933803:0
crwdns2933797:0Rylan Lukecrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Rylan Luke
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [* black] OPTIONAL: Install missing components. This requires purchase of additional components from mouser.com. See the |
|---|---|
| + | [* black] OPTIONAL: Install missing components. This requires purchase of additional components from mouser.com. See the guide parts list for more info. The image shows the location of the new components; you'll also need to install IC307. |
| [* black] Seriously, though, if you're going to add the missing components, buy the schematic online so that you have the PCB layout and schematic available for reference. | |
| [* black] It is difficult to solder these components in place, due to the large nearby cap (C382). I removed it before installing the missing components, and then reinstalled it, although the ground plane made this difficult to unsolder. | |
| [* black] You also MUST remove the 4 zero ohm resistors (as shown with a red line through them in the image). | |
| [* black] There is one additional step to take: disable the power amp. This is done by removing the main board from the lower case, and shorting together pins 2 and 4, to hold the power amp in standby. This step is not necessary if the missing components are not installed. |