crwdns2933803:05crwdne2933803:0
crwdns2933797:0Emmett Normandcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Emmett Normand
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* red] Remove this Phillips head screw |
|---|---|
| + | [* green] Disconnect the DC connector it can be identified as having only 2 wires |
| + | [* orange] Disconnect the power button it is a temporary switch and can be identified as having 4 wires |
| + | [* blue] Disconnect the Hall effect sensor it can be identified by having 6 wires. A hall effect sensor is used to tell the board where the motor is in its rotation. |
| + | [* icon_note] You will most likely need to remove silicone and hot glue to remove the connectors |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0