crwdns2933803:03crwdne2933803:0
crwdns2933797:0Ben Markeycrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Ben Markey
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [* black] Next, remove battery from its case by peeling off the clear sticker that is over the battery |
|---|---|
| - | [* black] Then pull the battery out of the casing, making sure not to tear the wires |
| - | [* black] Note: there is a piece of foam tape holding the battery inside which will rip when taking the battery out. As there isn't a way to determine the exact kind of tape it is, to be on the safe side heat/electrical resistant tape should be used to replace this |
| + | [* black] Then, unsolder the wires attached to the battery from the motherboard |
| + | [* black] There are two wires (there should be one red and one black), they will be connected to the B+ and the B- terminals on the motherboard. The wire attached to the B- terminal should be unsoldered first. |