crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:02crwdne2933803:0

crwdns2933797:0Connorcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Connor

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* black] After removing the screws, the sensor board is moved from the plastic mounts holding it to the projector.
+[* black] Remove the IR sensor from the plastic mounts with care not to strain the attached wire.
[* black] Turn the sensor over to reveal the wire harness and clip.
-[* black] Using a #2.5 flathead screw driving, pry out the wire harness from the clip.
-[* icon_caution] ''Caution:'' The clip is small and fragile. Use care when pressing the tip of the screwdriver onto the clip to avoid breaking.
+[* black] Use a small flathead screw driver to gently pry out the connector from its socket.
+[* icon_caution] The connector is small and fragile. Use care when pressing the tip of the screwdriver onto the clip to avoid breaking it.