crwdns2933803:06crwdne2933803:0
crwdns2933797:0epitrakoucrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 epitrakou
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Disassembling the Fan | |
| - | [* black] Using a small Phillips screwdriver remove the single screw from the centre of the fan. |
| + | [* black] Using a small Phillips screwdriver, remove the single screw from the centre of the fan. |
| [* black] Grab around the side of the fan and pull directly upwards to remove from the motor. This may require a decent amount of force. | |
| [* black] Pressing gently on the side, carefully remove the 2 pin connection for the motor from the PCB. | |
| [* black] Again using a small Phillips screwdriver, remove the 4 screws from the fan housing. | |
| [* black] Make sure the motor wire is free and untangled. Once it is free remove the entire housing from the robot. | |
| [* black] Once the housing is removed, using a small Phillips screwdriver, remove the 2 screws holding in the motor and detach the motor from the housing. |