crwdns2933803:03crwdne2933803:0
crwdns2933797:0Drewcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Drew
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Disassemble the board |
|---|---|
| + | [* black] Remove the M1 & M2 bumpers with two PH #1 screws (red) |
| + | [* black] Unplug the four rumble motors (green) |
| + | [* black] Unscrew the board from the controller with two PH #2 screws (blue) |
| + | [* black] Carefully flip the board until you can get to the ribbon cable |
| + | [* black] Flip the gray clip up to release the ribbon cable |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0