crwdns2933803:02crwdne2933803:0
crwdns2933797:0Connorcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Connor
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [* icon_note] The screen is attached with adhesive. |
|---|---|
| + | [* icon_note] The screen is attached with adhesive. |
| [* icon_note] Do not heat the device too much, stop at regular intervals and insure that no pieces are being affected badly. | |
| - | [* black] Use the heat gun or the iOpener, and heat the back of the screen enough for the adhesive to loosen up. |
| - | [* red] Take the jimmy and start to pry from the left side. Once pried far enough, take a opening pick and put it in the opening the deepest you can. |
| - | [* red] Go around the device and repeat the last step. |
| + | [* black] Use a hair dryer to gently heat the rear of the screen until it's almost too hot to touch. |
| + | [* black] Insert a jimmy between the screen and plastic bracket. Once a slim gap is opened, insert an opening pick between the plastic bracket and rear screen. |
| + | [* icon_note] Reheat the screen as needed. |
| + | [* black] Continue to insert opening picks around the entire perimeter of the screen as you pry to avoid the adhesive from reengaging. |
| + | [* black] Once the screen fully releases, remove it. |