crwdns2933803:05crwdne2933803:0
crwdns2933797:0Connorcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Connor
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [* red] Use a |
|---|---|
| + | [* red] Use a Phillips #1 screwdriver to remove the four 1.3 cm screws holding down each driver. |
| [* black] Gently pull the plastic plate towards the antenna cable. | |
| [* icon_caution] There is a small antenna cable that is easy to rip off the solder joint, so lift carefully. | |
| - | [* icon_note] There |
| + | [* icon_note] There are 8 screws on the long side of the housing, but there is no driver behind it, so you don't need to remove them. |