crwdns2933803:03crwdne2933803:0
crwdns2933797:0Nigelcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Nigel
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Pick and pry | |
| [* green] Using a suction cup, lift the middle right side and insert a pick and/or plastic card into the gap, slowly slice left and right | |
| [* light_blue] Do the same from the middle top side | |
| [* violet] Again from the middle left side | |
| [* orange] Lastly, from the middle bottom side | |
| [* red] Once again, watch out for the display flex connector | |
| [* icon_caution] If the pick doesn't slice through, don't force it, instead continue to apply heat and try again. Try not to insert the pick too deep. | |
| + | [* icon_caution] Once the display can lift free, DO NOT SEPARATE THEM JUST YET! |