crwdns2933803:03crwdne2933803:0
crwdns2933797:0Nigelcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Nigel
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Pick and pry |
|---|---|
| + | [* green] Using a suction cup, lift the middle right side and insert a pick and/or plastic card into the gap, slowly slice left and right |
| + | [* light_blue] Do the same from the middle top side |
| + | [* violet] Again from the middle left side |
| + | [* orange] Lastly, from the middle bottom side |
| + | [* red] Once again, watch out for the display flex connector |
| + | [* icon_caution] If the pick doesn't slice through, don't force it, instead continue to apply heat and try again. Try not to insert the pick too deep. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0