crwdns2933803:02crwdne2933803:0
crwdns2933797:0Job McKeecrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Job McKee
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Remove turntable |
|---|---|
| + | [* black] Pop the cap out with a flat pry tool. |
| + | [* black] Loosen the T15 screw. You don't need to remove it. |
| + | [* black] Pry on both sides of the turntable so that it comes up and out. |
| + | [* black] To reinstall it, make sure the motor-facing side goes in first, to make good contact with the stepper motor gear teeth. |
| + | [* black] If the stepper motor-facing side does not get reinstalled first, the table will not sit properly. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0