crwdns2933805:0crwdne2933805:0
crwdns2933797:0Jacob Mehnertcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Jacob Mehnert
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Flashing Car Thing |
|---|---|
| + | [* black] Once you have the tools installed you'll need to enter Car Thing's USB mode. |
| + | [* black] Disconnect your Car Thing from your computer, and hold buttons 1 and 4 (As shown in the photo to the left). Plug in your deivce while holding the two buttons. |
| + | [* black] Wait a few seconds, and if the screen does not turn on, then you've successfully entered the Boot Mode, and can release the buttons. |
| + | [* black] Once plugged in enter the command, ''python superbird_tool.py --burn_mode'' |
| + | [* black] The UART Console output should have an output ending with ***DRAM: 512 MiB; Relocation Offset is: 16e42000; InUsbBurn; [MSG]sof; Set Addr 11; Get DT cfg; Get DT cfg; set CFG*** |
| + | [* icon_caution] This step may say it fails to enter burn mode. This is okay, continue on as if it worked. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0