crwdns2933423:0crwdne2933423:0

crwdns2933803:01crwdne2933803:0

crwdns2933797:0Jaccrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Jac

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

+[title] Remove motor assembly
+[* red] Unscrew the two 5mm M4 phillips screws.
+[* blue] Unscrew the 7mm phillips screw.
+[* yellow] Pull off the 25mm gear. (This usually allows the adjacent gear (green arrow) to come off with the motor/ drive assembly; if it doesn't, this gear can be put back on afterwards).
+[* black] Pull away the main drive motor/gear assembly from the printer to remove.
+[* black] The 25mm drive gear (yellow arrow) and 30mm gear (orange arrow) can be replaced once the motor assembly is removed.

crwdns2933777:01crwdne2933777:0

crwdns2933779:0crwdne2933779:0

crwdns2915182:0crwdne2915182:0

crwdns2933777:02crwdne2933777:0

crwdns2933779:0crwdne2933779:0

crwdns2915182:0crwdne2915182:0

crwdns2933777:03crwdne2933777:0

crwdns2933779:0crwdne2933779:0

crwdns2915182:0crwdne2915182:0