crwdns2933805:0crwdne2933805:0
crwdns2933797:0Caleb Karlsoncrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Caleb Karlson
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [* black] Once you fit the base cover on the back correctly, begin pressing down on the edges to push the clips back into place. This is important to do before you screw the screws in. | |
| - | [* black] Begin by screwing in the four captive screws, (refer to |
| + | [* black] Begin by screwing in the four captive screws, (refer to Step 3 to find where they are located). After they are screwed in, push down each side another time. |
| [* black] Screw in the four M2x6(6mm) non-captive screws. As you do this, you should hear the last couple clips get pushed back into place. After each screw, continue pushing its respective side. Eventually, all the screws should be pushed back in and you should be finished. | |
| - | [* black] Lastly, do one final push on each side, tightening each screw afterwards. Congratulations, you are finished with the guide! |
| + | [* black] Lastly, do one final push on each side, tightening each screw afterwards. Congratulations, you are now finished with the guide! |