crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:04crwdne2933803:0

crwdns2933797:0Connorcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Connor

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

-[* red] Use a TR6 screwdriver bit and unscrew the two 5mm screws holding the power board together
-[* black] Carefully lift the board without tugging on the ribbon cable.
-[* black] Using the opening tool, carefully lift the black tab on the connector towards the ribbon cable.
-[* black] Pull and remove the ribbon cable.
+[* red] Use a Torx TR6 screwdriver to remove the two 5 mm screws that secure the power board.
+[* black] Carefully lift the board without straining the ribbon cable.
+[* black] Using an opening tool, carefully flip up the black ZIF locking flap that secures the ribbon cable.
+[* black] Disconnect the ribbon cable.