crwdns2933803:03crwdne2933803:0
crwdns2933797:0Zephoskcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Zephosk
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] Carefully lift the back cover partially off of the camera. |
|---|---|
| + | [* icon_caution] There are two ribbon cables still connecting the back cover to the camera. |
| + | [* red] Disconnect the right most ribbon cables from the main PCB board. |
| + | [* black] Use a plastic spudger to lift up the black locking tab. |
| + | [* black] Pull out the ribbon cable from its connector using a pair of angled tweezers. |
| + | [* icon_note] With this ribbon cable disconnected, you will be able to move the back cover slightly farther away from the camera, giving you more room to remove the remaining ribbon cable. |
| + | [* orange] Remove the left ribbon cable using the same two steps as with the other ribbon cable. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0