crwdns2933803:01crwdne2933803:0
crwdns2933797:0Zephoskcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Zephosk
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Removing the Lens Mount |
|---|---|
| [* icon_caution] If possible, try to work in an environment with minimal dust. The goal is to try to avoid dust from getting inside of the lens as much as possible. | |
| [* red] Remove the 2 screws on the side of the lens mount, holding in the contact assembly. | |
| [* orange] Next, unscrew the 4 screws holding the lens mount onto the lens. | |
| + | [* yellow] Carefully lift up one side of the lens mount (side opposite of the lens contact). Push the black plastic cover out of the lens mount. Take note that there are 4 plastic clips around the cover. These clips can break easily if you're not careful. |
| + | [* icon_caution] Be careful when lifting up the side of the lens mount. The lens contact is still attached to the lens mount with a ribbon cable that is attached to the main PCB board. |
| + | [* green] Push the lens contact off of the metal lens mount and set the lens mount to the side. |