crwdns2933805:0crwdne2933805:0
crwdns2933797:0Nick Schultzcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Nick Schultz
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Solder C3 | |
| - | [* black] Insert wisdom here. |
| + | [* black] Place the smaller 22 nF capacitor (with no label on its packaging) in the outline labeled "R4" on the board. |
| + | [* black] Re-heat the solder while holding the capacitor in its outline, so that its end caps (the shiny parts) are resting on the circuit board's pads. |
| + | [* black] Press the tip against the second C3 solder pad and the capacitor's second end cap for a few seconds to heat them both. Angle the tip so it has maximum contact with the pad and cap. |
| + | [* black] Feed the solder wire into the heated area until there's a concave pool of solder surrounding the end cap. |
| + | [* black] Remove the solder wire first, then remove the soldering iron from the pad. |