crwdns2933803:025crwdne2933803:0
crwdns2933797:0Nick Schultzcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Nick Schultz
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Solder the power inductor |
|---|---|
| [* black] Press the iron's tip against the circuit board's "L1" solder pad for a few seconds to heat it, then feed the solder wire into the heated area until there's a concave pool of solder on the pad. | |
| [* black] Re-heat the solder while holding the inductor in its outline, so that its end caps (the sides with the notches) are resting on the circuit board's pads. | |
| [* black] Remove the iron, then remove the tweezers once the solder has cooled. |