crwdns2933803:015crwdne2933803:0
crwdns2933797:0Nick Schultzcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Nick Schultz
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Solder the LED | |
| [* black] Press the iron's tip against the circuit board's ***LED*** solder pad for a few seconds to heat it, then feed the solder wire into the heated area until there's a small glob of solder on the pad. | |
| [* black] Place the LED in the outline labeled ***LED*** on the board, with the white (non-green) side aligned with the "***+***" symbol. | |
| [* icon_note] The green markings indicate the negative (***-***) side. | |
| + | [* black] Solder the LED's first end cap to the board. |
| + | [* icon_note] The LED's contact pads are underneath it, so the solder joint doesn't need to cover the entire end. |