crwdns2936637:0crwdne2936637:0 crwdns2853008:0crwdne2853008:0 crwdns2918746:0crwdne2918746:0

crwdns2933803:04crwdne2933803:0

crwdns2933797:0Nick Schultzcrwdnd2933797:0crwdne2933797:0

crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Nick Schultz

crwdns2933769:0crwdne2933769:0
crwdns2933771:0crwdne2933771:0
crwdns2933801:0crwdne2933801:0

crwdns2933807:0crwdne2933807:0

[* black] Set down the circuit board on your work mat/surface so the front (the side labeled "MiNi-DSO" at the top) is facing up.
-[* black] Place one of the 2 kΩ resistors (labeled 202) in the outline labeled "R1" on the board.
+[* black] Place the largest 10 kΩ resistor (labeled 103) in the outline labeled "R4" on the board.