crwdns2933803:09crwdne2933803:0
crwdns2933797:0Nick Schultzcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Nick Schultz
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Solder the resistor | |
| [* icon_note] You're going to heat the solder pad and the resistor's lead ***very hot for 2 to 3 seconds***. The pad and lead should readily melt the solder wire. | |
| [* black] Press the tip against the circuit board's solder pad and the resistor's lead for about 1 second to heat them both. Angle the tip so it has maximum contact with the pad and lead. | |
| - | [* icon_caution] If you heat the circuit board continuously for more than 10 seconds, the excessive heat may damage the solder pad or |
| + | [* icon_caution] If you heat the circuit board continuously for more than 10 seconds, the excessive heat may damage the solder pad or resistor. |
| [* black] Feed the solder wire into the heated area until there's a concave pool ("mini volcano") of solder surrounding the lead. | |
| - | [* icon_note] This should happen within a few seconds. If the solder doesn't adhere to the pad, apply flux to the pad or increase the temperature. |
| [* icon_note] Don't feed the solder directly onto the tip as it won't flow properly into the pad and lead causing a weak connection. | |
| - | [* black] Remove the solder wire, then remove the soldering iron from the solder pad. |
| + | [* icon_note] The volcano should form within a few seconds. If the solder doesn't adhere to the pad, apply flux to the pad or increase the temperature. |
| + | [* black] Remove the solder wire, then remove the soldering iron from the pad. |
| [* black] Repeat this process for the second resistor lead. |