crwdns2933805:0crwdne2933805:0
crwdns2933797:0Ryan Gurnickcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Ryan Gurnick
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Refitting the motor cable connector |
|---|---|
| + | [* black] Now make sure the Smartunit Main ECU is pulled out, for not more than 2-3 cm, under an angle of 45° , so the connectors are partly visible as shown in the picture. |
| + | [* black] Now let’s check the motor cable connection. There are 4 connectors at the front end of the Smartunit Main ECU. The motor cable connector is the biggest of the 4 connectors, positioned next to the small yellow connector, see picture. The gap between the connector and the Smartunit Main ECU should not be more than 1mm. |
| + | [* black] If there is a bigger gap, the connector is not connected properly. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0