crwdns2933803:06crwdne2933803:0
crwdns2933797:0Sarah Westbergcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Sarah Westberg
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [* black] Using a 2.5 millimeter hex tool, unscrew the hex screws that connect the two pieces of the X10 casing. |
|---|---|
| - | [* red] There are 10 17.5mm hex screws holding the casing halves together. |
| - | [* icon_note] Several of these hex screws are in deep, narrow holes in the casing. We recommend using a full-length hex key rather than a hex bit at the end of a driver. |
| + | [* red] Use a 2.5 millimeter hex key to remove the ten 17.5 mm screws that connect the two halves of the X10 casing. |
| + | [* icon_note] Several of these hex screws are in deep, narrow holes in the casing. We recommend using a full-length hex key rather than a hex bit at the end of a driver. |
| [* black] Separate the two halves of the casing using the metal spudger to pry apart the 10 connection arms that form the structure of the casing. | |
| - | [* icon_note] If this is the first time opening the casing of this X10, there will be glue around the seam of the casing. Use the spudger to split the glue to loosen the seam. |
| + | [* icon_note] If this is the first time opening the casing of this X10, there will be glue around the seam of the casing. Use the spudger to split the glue to loosen the seam. |