crwdns2933803:06crwdne2933803:0
crwdns2933797:0Sam Gustafsoncrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Sam Gustafson
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Remove auto/manual switch lever |
|---|---|
| + | [* red] Unhook one end of the coil spring. |
| + | [* orange] Slide the stamping so the larger end of the keyhole can be lifted off the screw. |
| + | [* yellow] Remove the stamping from the post on the lens board using the same method. |
| + | [* green] Remove one X mm flat head screw. |
| + | [* icon_note] ''Installation Note:'' Remove the old grease with isopropyl alcohol. Reapply a thin film of molybdenum disulfide grease to the sliding surfaces of the stamping and the switch lever. The action should be much cleaner. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0