crwdns2933803:013crwdne2933803:0
crwdns2933797:0Zephoskcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Zephosk
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Install the Gear Ring 1 | |
| [* red] Position the gear ring above the intermediate barrel as you have removed the gear ring, otherwise the ring will not fit into place. | |
| [* icon_note] You may notice that the inside of the gear ring has some nubs, which lines up with indents on the inside of the intermediate barrel. | |
| [* orange] Lower the gear ring onto the intermediate barrel and then rotate the gear ring clockwise until the zoom brush is back over the ribbon cable. | |
| [* icon_caution] Again, be very careful with the zoom brush as to not bend its pins. | |
| - | [* yellow] Screw in the zoom ribbon cable screw. |
| - | [* green] Screw in the |
| + | [* yellow] Screw in the Phillips #00 zoom ribbon cable screw. |
| + | [* green] Screw in the two JIS #000 gear ring limit screws. |