crwdns2933803:01crwdne2933803:0
crwdns2933797:0DegenFixercrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 DegenFixer
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] Begin by heating the back panel (where the cameras are). |
|---|---|
| + | [* icon_note] I use a heating pad set to 100 Celsius for this job. Usually put it on before it's heated, then let it sit 6-7 minutes at 100. |
| + | [* icon_note] You can use a heat gun instead. Just make sure to heat all the surfaces ''enough''. How much ''enough'' is, you will have to find out. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0