crwdns2933803:03crwdne2933803:0
crwdns2933797:0Christian Diazcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Christian Diaz
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] Lay the X-10 on its back so that the bottom is facing you and the front panel is facing upwards. |
|---|---|
| + | [* black] Using the metal spudger, separate the two connection points located on the left and right sides of the mesh panel as shown. |
| + | [* black] Finally, separate the connection point in the center of the bottom section of the mesh panel. |
| + | [* black] As before, all connection points should audibly 'pop' when disconnected, and the mesh panel will be visible separated from the body of the X-10. |
| + | [* icon_note] Be careful not to accidentally re-connect the points that you have already separated. It may be helpful to insert shims to hold open the connections you have opened as you finish the step. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0