crwdns2933803:03crwdne2933803:0
crwdns2933797:0Scottcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Scott
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Removing the RF module |
|---|---|
| [* black] Remove the RF module as follows: | |
| [* black] Remove a Phillips PH1 x 6mm screw from the left side of the black plastic bracket. | |
| [* black] Remove a skinny Phillips PH0 x 7mm screw from the right side of the plastic bracket. | |
| [* black] Slide the black plastic bracket carefully from underneath the display ribbon cable towards the left, and set it aside. | |
| [* black] The RF module is now held by a clip at the bottom, a small round locator pin on the lower right, and a connector at the top edge, underneath. Use a spludger at the top edge to pry the RF module connector loose. It will pop off. | |
| [* black] Now just lift and slide the RF module up, and will clear the tab at the bottom. Set the RF module aside. |