crwdns2933803:03crwdne2933803:0
crwdns2933797:0Scottcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Scott
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] Remove the RF module as follows: |
|---|---|
| + | [* black] Remove a Phillips PH1 x 6mm screw from the left side of the black plastic bracket. |
| + | [* black] Remove a skinny Phillips PH0 x 7mm screw from the right side of the plastic bracket. |
| + | [* black] Slide the black plastic bracket carefully from underneath the display ribbon cable towards the left, and set it aside. |
| + | [* black] The RF module is now held by a clip at the bottom, a small round locator pin on the lower right, and a connector at the top edge, underneath. Use a spludger at the top edge to pry the RF module connector loose. It will pop off. |
| + | [* black] Now just lift and slide the RF module up, and will clear the tab at the bottom. Set the RF module aside. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0