crwdns2933803:01crwdne2933803:0
crwdns2933797:0Spencer Penningtoncrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Spencer Pennington
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Remove the front trim | |
| [* black] Place the controller on a work surface with the joysticks facing down. | |
| [* black] Use a spudger or your finger to slide the ***Release*** tab to the left. The front trim should fall to the table. | |
| [* icon_note] If the front trim doesn't fall open, make sure the front trim has room to fall down and the ***Release*** tab is pushed all the way to the left. | |
| [* black] Lift the controller up, leaving the front trim on the table. | |
| + | [* icon_reminder] During reassembly, [link|https://guide-images.cdn.ifixit.com/igi/NDZEviBRE3mmJNVC.full|insert the front trim at an angle|new_window=true] so the top slots in first, then lower the trim into place and snap it onto the controller. |