crwdns2933803:021crwdne2933803:0
crwdns2933797:0Jeremy Mikesellcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Jeremy Mikesell
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Install front glass |
|---|---|
| + | [* black] Clean the from glass to remove all leftover OE adhesive using light abrasive like ScotchBrite |
| + | [* icon_caution] Be careful when cleaning the inside of the glass as the markings are printed on this side and can be scraped off or damages |
| + | [* black] Clean the inside of the glass very well. This is your last chance and finger prints or dust on the inside will be there forever. |
| + | [* black] Clean the edges of the glass and mating surface on the housing with isopropyl alcohol. |
| + | [* black] Apply a very small bead of RTV sealant the entire way around the housing. Be sure there are no gaps in the bead. A syringe with a small dispensing needle is very helpful for this step |
| + | [* black] Place the front glass, be sure the it is right side up. Push down into place fully |
| + | [* black] Clean of excess RTV from the outside by wiping with isopropyl and a clean cloth. |
| + | [* black] Is you mess up or have any concerns about the amount of adhesive you used immediately remove the glass. Clean off all the uncured adhesive with IPA and repeat this step. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0