crwdns2933803:08crwdne2933803:0
crwdns2933797:0Jeremy Mikesellcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Jeremy Mikesell
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Remove the Main PCB |
|---|---|
| + | [* black] Cut the RTV blobs on each side of the PCB free from the housing. You do not need to remove this material, just cut it free from the housing. Running a metal pick around the edge works well. |
| + | [* black] This RTV is covering an indicator LED and the ambient light sensor. Be careful not to damage these components. |
| + | [* black] Remove the two screws on the PCB |
| + | [* black] The PCB is also stuck down with thermal compound and may be difficult to break lose. Heating the back of the main housing might help soften this material. |
| + | [* black] Try to remove by pulling on the edge of the PCB near the connectors. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0