crwdns2933803:04crwdne2933803:0
crwdns2933797:0Shane Lawsoncrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Shane Lawson
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| - | [* black] Remove the T20 screw at the rear of the handle. |
|---|---|
| + | [* black] Remove the tamper-resistant T20 screw at the rear of the handle. |
| [* black] Once removed, pry back the bottom portion of the cover. | |
| [* black] This exposes a plastic tab from the upper part of the handle that locks over the screw post in the interior of the handle. | |
| [* black] Lever the tab off of the post and proceed to remove the rest of the upper part of the handle from the interior by separating at the seams along the sides. | |
| [* black] At this point you should have access to the on/off switch, if that was your goal, otherwise there is a circuit board that the LED attaches to (with the floor setting indicator LEDs) that is accessible behind one or two more screws. |