crwdns2933803:04crwdne2933803:0
crwdns2933797:0Philip Wencrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Philip Wen
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| [title] Projector arm pivot subassembly | |
| [* black] Remove the pivot pin ''(27.3g)'' from the main projector arm, it pops out after removing the clasp washer using a pair of pliers, pushing it out. The film reels fit onto the long cylindrical section, one on each side of the arm. | |
| - | [* black] I believe the pivot pin can be further dissected, however I was unsure how to and lacked the tools as well. |
| + | [* black] I noticed ball bearings that are very well imbedded into the shaft, and I suspect the pivot is made of two parts connected- head and shaft, however I was unsure how to further dissect and lacked the tools to do so. |
| + | [* black] The pivot had two stainless steel washers as shown in the picture and a clasp washer which clicked on after the pivot passed through the film reel arm hole. The clasp stopped the pivot pin from sliding out of the hole. |
| [* green] Length: 42.5mm | |
| [* light_blue] Diameter: 22.0mm | |
| [* yellow] Diameter: 13.9mm |