crwdns2933803:07crwdne2933803:0
crwdns2933797:0Joshua Byrnecrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Joshua Byrne
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Replacement Note: Existing Heatsink |
|---|---|
| + | [* icon_note] Perform the following steps once you have installed the new processors and ready to re-install the heatsinks. |
| + | [* black] Preparing an EXISTING Heatsink for Re-installation. If you have a new heatsink, follow the NEW Heatsink procedure. |
| + | [* black] Using the alcohol pad included with the logic board or processor replacement part, clean off any used thermal grease from the processor and the bottom of the heatsink. |
| + | [* black] Using the thermal grease included with the logic board or processor replacement part, apply one dot of fresh grease to the raised square area on the bottom of the heatsink. |
| + | [* black] Spread the grease evenly across the square to a thickness of approximately 1 mm. |
| + | [* icon_caution] Warning: Do not apply more grease than recommended. The grease must not overflow the heatsink and come in contact with the processor connector. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0