crwdns2933803:010crwdne2933803:0
crwdns2933797:0Dave Fixeditcrwdnd2933797:0crwdne2933797:0
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] Slide the housing back over the magsafe connector. It goes on either way round (there is a hole for the led on both sides. |
|---|---|
| + | [* black] Squeeze in place with the pliers. If it doesn't fit over the circuit board fairly easily, check that you don't need to file down the solder joints some more. |
| + | [* black] Slide the first of the pieces of heatsink up against the plastic housing. |
| + | [* black] Keeping it tight, shrink it in place. This is important to help avoid a future failure. |
| + | [* black] Repeat with the outermost piece of heatshrink. |
| + | [* black] Try powering it up! Remember that it will take a few seconds before the LED illuminates. |
| + | [* black] Orange light - success! |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0