crwdns2933803:07crwdne2933803:0
crwdns2933797:0Dave Fixeditcrwdnd2933797:0crwdne2933797:0
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] Make sure that the cable comes off the centre of the circuit board so the housing will fit over it. |
|---|---|
| + | [* black] Also check that there is about 3mm of stripped cable on top of the circuit board as the strain relief has to fit here (see next photo) |
| + | [* black] Solder the other braid on the other side, in the opposite corner to the core. Try not to extend beyond the edge of the circuit board |
| + | [* black] Carefully file off any solder or cable that extends beyond the end of the circuit board. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0