crwdns2933803:01crwdne2933803:0
crwdns2933797:0Dave Fixeditcrwdnd2933797:0crwdne2933797:0
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] Place the pliers on the worksurface with the metal section of the magsafe between the jaws and the white plastic housing resting on the jaws. |
|---|---|
| + | [* black] Cut off the cable as close to the housing as possible. |
| + | [* black] Use a cross-head screwdriver to force the metal section of the magsafe out of the plastic housing |
| + | [* black] Gently prise apart the strain relief metal band around the remains of the cable and put it aside for later. |
| + | [* black] Cut down one side of the soft plastic inner and peel it away from the wires and circuit board. You are very unlikely to be able to re-use it so don't worry if it tears. |
| + | [* black] The image shows roughly what you should now have. The braid is soldered to two places (one on each site of the circuit board at opposite ends); the white core is soldered in just one. |