crwdns2933803:03crwdne2933803:0
crwdns2933797:0Mice Principalcrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Mice Principal
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Removing Circuit Board. |
|---|---|
| + | [* black] Desolder the battery tabs and mask them off with electrical tape. You will need to use a fairly large soldering iron tip due to the side of the pads. You may well find you need to use an (ideally non-conductive) tool to lift the tabs clear. |
| + | [* black] Once all the tabs are clear, masked, remove all the phillips head screws from the board (several of which I have managed to lose by the time the photograph was taken). |
| + | [* black] Carefully begin lifting the circuit board and the adhesive paper underneath as evenly as possible from all sides. Waggle it a little to begin to loosen it but not too much. |
| + | [* black] ***Take care whilst lifting as there are three thermistors going down amongst the cells from the board. and you do not want to damage them.*** |
| + | [* black] When the board is free, place it to one side. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0