crwdns2933803:01crwdne2933803:0
crwdns2933797:0Tim Elafroscrwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Tim Elafros
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [* black] Looking at the sensor from the bottom, you can see the two tabs/prongs that hold the outer case together. |
|---|---|
| + | [* icon_caution] There is a fine cable attaching the internal components of the PM sensor. Be careful not to disrupt/break it. |
| + | [* black] The internal housing will now be exposed. You can use the two tabs/prongs on this porting to remove that portion of the case. |
| + | [* black] Next, you can remove the 4 small screws holding the internal components to the outer shell. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0