crwdns2933803:08crwdne2933803:0
crwdns2933797:0Michel_K17crwdnd2933797:0crwdne2933797:0
crwdns2936043:0crwdne2936043:0 crwdns2933505:0crwdne2933505:0 Michel_K17
- crwdns2933769:0crwdne2933769:0
- crwdns2933771:0crwdne2933771:0
- crwdns2933801:0crwdne2933801:0
crwdns2933807:0crwdne2933807:0
| + | [title] Remove excess material from the stem |
|---|---|
| + | [* black] Using a dremel, carefully remove some of the nylon all the way around until the bearing slides all the way down. This took about an hour, and I had the stem mounted on a vertical stick so I could rotate while using the dremel. |
| + | [* black] Use rough sandpaper (~150) to smooth out the edges of the dremel wheel. |
| + | [* black] Verify that the new bearing fits square to the mark of the old bearing. Note that the mark will be worn down by the dremel , so keep re-marking it with the old bearing. |
crwdns2933777:01crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:02crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0
crwdns2933777:03crwdne2933777:0
crwdns2933779:0crwdne2933779:0
crwdns2915182:0crwdne2915182:0